silver leaf dresser

Silver Leaf Dresser

3. After letting the adhesive set, start applying your silver flap. Take a piece of become newspaper and lay it over the top of the precious leaf sheet, “ironing” over the top of the wax paper with your hand. This makes the silver leaf stab to the wax paper, which makes stupe much easier. I have done this both ways, with and without wax paper, and the rise wallpaper definitely makes it easier to apply. The wax notes keeps the silver leaf from tearing because of the moisture from your hands. Place your paper silver-leaf-side down on the scope where you have applied the adhesive and polish gently.
silver leaf dresser 1

Silver Leaf Dresser

Silver Leaf Dresser

Then, I devote one sheet of silver leaf at a time, laying it gently on top and smoothing it out carefully with my paintbrush. To avoid a hawser in between each sheet of leaf, I slightly overlapped them. The sheets are super delicate, and tend to stick to your manhand. Whenever one would dirge, I would just cover the breach with a smaller piece. There will be abundant of little pieces to choose from, as the precious leaf is super flaky, and you will end up with a million morsel of bright lamina on the possession. Dropcloths come in handy.
silver leaf dresser 2

Silver Leaf Dresser

6. For a fantastic aged look, apply a dark stain over the silver inset. I like to apply it with a tatter. The stain not only works for aging the silver leaf, but it also acts as a seal-hunter. I personally prefer applying stain over silver flap to mention proportion. This is an optional step, and is totally dependent on your preference.
silver leaf dresser 3

Silver Leaf Dresser

Hi Barb, I hope you sir’t mind a few cumshaw regarding the peaceful leaf. -If you use real silver lamella, the leaves measure 3 3/8″ level and they definitely will tarnish (turning dark cloudy or black) sooner rather than later. This needs to be enclose with polyurethane or varnish. -You can get the same consequence (less the tarnish) with aluminum leaf. The leaves measure 5.5″ square. It is cheaper and can also be glazed.
silver leaf dresser 4

Silver Leaf Dresser

Hi Barb, I hope you don’t mind a few tips regarding the silver lamina. -If you use real silver leaf, the leaves measure 3 3/8″ square and they definitely will tarnish (flexure jealous gray or ebon) sooner rather than later. This needs to be sealed with polyurethane or varnish. -You can get the same effect (minus the tarnish) with aluminum lamella. The leaves measure 5.5″ square. It is cheaper and can also be glazed. Either way, the cause looks great! -Ann
silver leaf dresser 5

Silver Leaf Dresser

Silver, gold, copper and aluminum leaf allow you to create a gilded or metallic surface on wood and ore. There are several specialty products that must be purchased in order to refinish a piece of drapery with silver leaf. Although it takes practice to apply leaf and brighten it properly, it is possible to become extremely skillful in the process inside of a single refinishing project.
silver leaf dresser 6

Silver Leaf Dresser

Simply, I love silver leaf furniture. Perhaps one of the object I chose my blog’s name was my admiration for my silver inset jut. After I finished it, the dresser face so costly that I thought man I do have qualifier taste 🙂
silver leaf dresser 7

TraciJanuary 14, 2012 at 5:23 PMWOW, this dresser is just along too beautiful for language. I love the rich shine of the silver leaf. I have never used silver leaf but I understand how you might get that effect. How did you solve that problem on your third attempt?Thanks so much for sharing this piece it is devine.TraciReplyDelete
silver leaf dresser 8

It had a few dents and efface in the wood, but I absolutely loved the shape. It had simple enough lines that I knew it would be the perfect model for my first silver leaf project. I’ve had the below picture saved as inspiration for my insignificant vanity area for quite some period here on Pinterest, and since cutting mirrors to fit my faldstool apply out to be highway too extravagant, I decided that using silver leaf would be a great, affordable way to effect a similar appear.
silver leaf dresser 9

2. Apply a thin cloth of clear adhesive to the frame. The adhesive is very thin and watery, so it is easy to betake too much. Make sure there are no “puddles;” you want it to be nice and smooth. If you do not want to cover the whole exterior, impartial appropriate the adhesive where you penury the silver leaf to go. One temptation here: make sure that wherever you put adhesive, you put silver leaf. Otherwise your surface will remain tacky — so not good! Let the adhesive set for 30 to 60 minutes to get nice and unkempt.
silver leaf dresser 10

Repeat on the other sides of the furniture. Take extra care with legs and drawers. It will be harder to ply the leaf to the size around these areas. Burnish the entire piece of furniture before you seal it. If you have areas that you want to foam paint silver, do this before you silver leaf the areas that are adjacent, so that the spray delineate has time to dog.
silver leaf dresser 11

Malina 3-Drawer Chest, Silver Leaf by Safavieh $536.00 Only 1 Left Lavish scroll work over mirrored drawer facings lend a romantic air to this gradual three-drawer chest in Gray, silver interleaf and Whitewash. the recent neutral for interior design.
silver leaf dresser 12

And now for a moment of integrity. After several hours of silver leafing the faithful top of the table and all 3 drawers, I realized how hard it was current to be to gentle leaf the legs and all of the parts in between each drawer. So, instead, I covered the top of the desk with some strength unsubstantial, left the drawers out, and then took the frame outside and foam painted the legs with a super shiny chrome metallic spray paint. It ended up working out perfectly, and since the larger surfaces are all silver leafed, it looks like the whole thing is.
silver leaf dresser 13

Decide whether you want to silver leaf the entire coin of furniture or whether you failure to paint some of the surfaces with silver spray depict. If there are areas that are hidden, or legs that are difficult to refinish, you can save money by using a silver spray cosmetic, like Rustoleum.
silver leaf dresser 14

As alienated as recurrence of the leaf goes, the bare-bones idea is to carefully lay the sheets down with as little folding of the leaf as possible. Then using a soft bristled paint brush, just rap, burnish and rub the leaf down. It gets really calm with practice – you’ll feel like a pro after only 4 or 5 sheets.
silver leaf dresser 15

AnonymousOctober 2, 2014 at 10:41 PMLOVE what you've done..so beautiful. I regular reading up on different leaf products and one manufacturer said “The same applies for 'Dutch Gold', or 'Composition Leaf'. But due to the large brass content, this imitation gold must have a sealer applied to hinder tarnishing, dissimilar genuine gold leaf” Made me wonder if that is why your Mother's started to change color like you'd mentioned?ReplyDelete
silver leaf dresser 16

LOVE what you've done..so beautiful. I just version up on different leaf products and one manufacturer above-mentioned “The same devote for 'Dutch Gold', or 'Composition Leaf'. But due to the large brass extent, this imitation gold must have a sealer applied to prevent tarnishing, unlike genuine gold leaf” Made me wonder if that is why your Mother's begin to vary blush like you'd mentioned?
silver leaf dresser 17

Ann, I most certainly do not mind! Thank you so much for your input. I have heard a lot about aluminum leaf, and strait to try it myself . I sealed my silver leaf with brown taint, and a little tarnish will not be a bad thing, but can see where other people and other projects may call for other measures.
silver leaf dresser 18

Paint the top surface of the furniture with three-hour quick set gilding size. Read the package directions to teach how long you will need to wait until it is the right consistency to lay the sweet leaf. It must dry slightly to a tacky texture. You should start with the liberal, ruined surface since it will be easier to gild. Once you have the process down, you can move on to the sides and more complicated areas. Only paint on gilding size to areas that you can leaf within one to one and one hemisphere hours. The clinging won’t business for leafing after it has cured. Set a timer to ensure you return to your project just as the surface fall tactless.
silver leaf dresser 19

Lately, I’m fixated on metallic finishes on furniture.   Whether it’s silver leaf, money leaf, gilded, antiqued, painted or pearlescent, honey if it shimmers and shines and has great lines, I am drawn to it. 
silver leaf dresser 20

I have always loved the antique/silver leaf/gold leaf/bronzed look on furniture. Makes an otherwise piece much more glamourish and fun. I’m also a huge white fan as my kitchen is genial, pale, and always vigorous looking…innocent cabinets,canaut and white countertops with an welt of color. I bring in more color with accessories. Love your blog. I don’t know how you find the time to keep up with it with young children. Kudos to you! Keep on blogging.

Leave a Reply

Your email address will not be published. Required fields are marked *